In construction, a building or structure is waterproofed with the use of membranes and coatings to protect contents underneath or within as well as protecting structural integrity.

Integral systems work within the matrix of a concrete structure, giving the concrete itself a waterproof quality. There are two main types of integral waterproofing systems: the hydrophilic and the hydrophobic systems.

  • A hydrophilic system typically uses a crystallization technology that replaces the water in the concrete with insoluble crystals. Various brands available in the market claim similar properties, but not all can react with a wide range of cement hydration by-products, and thus require caution.
  • Hydrophobic systems use fatty acids to block pores within the concrete, preventing water passage.

Depending on the maintenance work schedule, Advanced Waterproofing Company in Johannesburg carries a guarantee of up to 10 years. A wide range of building defects can result in rainwater entering the building. The symptoms are usually obvious, for example, water dripping through a ceiling.

Acrylic Waterproofing System

The Acrylseal system consists of a combination of Acrylseal Waterproofer, and Acrylseal Membrane.

The most popular applications for the Acrylseal system are:

  • Waterproofing small roof areas
  • Waterproofing parapets
  • Repairing damaged flashings

Application of the Acrylseal system is simple. However, before starting, one should ensure that the area to be waterproofed is sound, stable, and free of detritus, oil, or any other substance that may prevent the system from achieving a good bond to the substrate.

The Acrylseal Waterproofer is first applied to the surface to be waterproofed. The Acrylseal Membrane is then applied immediately onto the wet Acrylseal Liquid. Once the Acrylseal Liquid has dried (2-24 hours, depending on weather conditions) a second coat of Acrylseal Liquid should be applied over the Acrylseal Membrane.

Torch-on Membrane

Torch-on Membrane is a bitumen-based waterproofing product which is heat-fused to underlying substrates. It is sold in a variety of thicknesses with single or dual re-enforcement with polyester or fiber glass.

Typical uses are the waterproofing of:

  • Roof slabs
  • Balconies and patios
  • Foundation walls
  • Retaining walls

Surfaces must be sound, clean and free from any contaminants and primed with one coat of Bitumen Primer prior to the application of the torch-on membrane. Once cooled, the membrane should be protected with 2 coats of Bitumen Aluminium Paint for UV protection or covered with a screed and tiling. Care should always be taken to ensure good overlaps between rolls and to lap any side walls to prevent water ingress. Refer to manufacturer’s guides for full application details.


This product is a water-based, rubberized bitumen emulsion, used with a membrane to form a liquid waterproofing system.

Typical uses:

  • All types of flashings.
  • Parapet walls.
  • Flat roofs smaller than 500m2.
  • Sealing joints, laps and roofing screws on corrugated roofs.


  • Suitable for use in potable water conditions.
  • Can be applied to damp surfaces.
  • Tough and flexible.
  • Excellent adhesion.

DO NOT apply if rain is imminent.
The product is not UV stable and requires a suitable bitumen-based reflective coating.